deutsch français
   
About us
 

TANYTARSUS

The soft technology for healthy lakes and rivers.

 

 

Aim

The aim is to support the lake, by symbiosis with natural phenomena, in its supply of oxygen. An oxygen-enriched environment results. Fertilizers, such as phosphor, decrease noticeably.

 

Method

Air or pure oxygen is conducted through small, flexible pipes from a land-base to the water. For both air and oxygen the same system is applied.

 

Mixing

During winter the cool water tends to mix naturally. This phenomenon is supported by injecting pressurized air to the lake bottom so that the oxygen-deficient water thus reaches the surface and absorbs oxygen from the air.

 

Other implementations are e.g.: summer destratification, mixing to control algal growth, mixing below an ice cover.

 

The lack of oxygen is often to be found in the lake-bed area while the oxygen content is sufficient in the hypolimnion of a thermally stratified lake (summer or under ice cover). In this case the TANYTARSUS  System is run in a way, that the mixing does not reach the metalimnion and a redistribution of oxygen in the hypolimnion is taking place without interfering with the stratification.

 

Oxygen input

Oxygen deficiency in the hypolimnion of a thermally stratified lake (summer or under ice-cover) is compensated by leading in air or pure oxygen in form of small bubbles which dissolve while ascending in the lower hypolimnion. So no lack of oxygen (due to increased demand) develops near the sediment.

 

Alternation in using the described running modes and combinations of them lead to an even greater flexibility and adaptation to nature.

 

Basic principles

- Optimal involvement of the environment in the restoration process

- Support of natural phenomena

- Maximum flexibility

- Soft and environmentally friendly technology

- No disturbance of the landscape and no construction on the water surface

- All mechanical parts are on land

 

Limitations

There are few technical limitations. Equipment can be installed in shallow water (i.e. a few meters) or in several hundred meters depth. At present the largest existing plant is installed in a lake with a water surface area of 14.4 km2, a water volume of 0.68 km3 and a maximum depth of 87 m. Installations for lakes of surface areas of more than 500 km2 as well as for lakes smaller than 0.03 km2 have been projected.

 

Cost

The investment is relatively small as no major equipment is necessary. The running costs are comparatively low and even decrease with the improvement of the water quality.

 

Experiences

Since 1982 research, design and managing experiences have improved.

 

Realization

For the most part, the construction of the plant can be executed by local companies, supported by our know-how. We also offer a general contractor agreement with a turn-key installation including all services like data collection, lake model (computer simulation), impact study, expertise, forecasts and design.

   
  TANYTARSUS: Diffusor test
  TANYTARSUS: Diffusor test
   
  Bubble plume.
  Bubble plume
Irrigation of de-icing effluents on snow
Disposal of de-icing effluents
Bubble plume
Lake Sempach
Nieuwe Meer

TANYTARSUS diffusor test

TANYTARSUS
Sediment retention basin, River Reuss near Erstfeld
River Reuss
References
Lakes and Rivers
Publications
Contact
Links
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Top
Home